Skip to main content

Help - Frequent questions?

A list of common config issues and the solutions?

Motor won't start​

  1. Is ARM mode configured?
  • Please check your Arm Mode has been enabled. See details in the Modes
  • Note!! Arm and Throttle hold need to be on different switches. The FC must see minimum throttle before Arm is enabled; therefore, if Arm activates at the same time as throttle hold is removed, it will fail the minimum check.
  • Check status page for Arming disables
  1. Using a Governor?
  • Does the Motor spool in Governor 'passthrough'. If not this could indicate a pin or timer alocation issue. Also please check your Reciever is connected and has the correct channel order.
  • Does the Motor spool in Governor 'Mode 1'. Please confirm you have either Frequency input or Bi-directional Dshot enabled and functioning. Using the Motor override run the motor at minimum speed and confirm there an RPM signal present
  • Governor mode 'Mode 2'. If the motor is able to spool in the other modes but not Mode 2 it means the Battery Voltage is not available. Please update this in the Power tab.

Telemetry​